Analogue Systems RS-450 CV Recorder
Dostępny na zamówienie
The RS-450 is a multifunctional module for multi-channel recording
of voltages, gates and trigger from external sources. This voltage
sequences can be recorded in 10 memories and can be recalled at any time for live use
Połączenie z serwerem jest szyfrowane z użyciem klucza SSL
SZYBKA DOSTAWA KURIEREM LUB PACZKOMATEM
darmowa dostawa do polski od 500 PLN
As the sampling frequency iof the RS-450 is high and the internal SD card is large enough it is also possible to record audio signals as well, just like with a sampler.
Recording CVs, gates and trigger on four channels with a sapling
frequency up to 14kHz i.e. audio recordings are possible too.
Module can be used as a sequencer as well because it has clock in-
and outputs and parameters for sequence start and end points. It can be played in realtime or in step time mode. Different playback
possibilities like forward, backward, bi-directional as well as single, repeat, and hold modes.
The functions start, stop, record and rest/reset can be activated
manually and with CVs as well.
Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2,5 mm) when mounting an Analogue Systems
module by the side of an Eurorack module. Take this into consideration when planning your system. Gaps can be covered with
1.5HP wide blank panels by Doepfer.
The RS-450 is the only Analogue Systems module so far with an
additional connector for Eurorack flat ribbon cables. It requires a ribbon cable with 16 pin headers on both ends. Please watch polarity! If the module is plugged in incorrectly and therefore
damaged the customer has to bear any costs for repair and shipping!
CV inputs for start- and end point of the sequence and the sampling frequency per channel of the CV recorder there´s a CV input and output
clock in, clock out
Gate inputs for the transport functions start, stop, record and rest/reset
3U Eurorack module, 36HP wide (see info above). 78mm deep
Current draw not known yet but probably it's high due the digital
Module requires an powerful +5V voltage like from Make Noise's 5V
adaptor or Mutable Instruments Volts.
Weight 0.482 kg