Doepfer A-100LC6V Low Cost Case 6 HE PSU3 Vintage Edition
Dostępny na zamówienie
Two rows with 84 HP for installation of modules. Same as the A-100LC6sw case but painted vintage black like the A-100 Minicase black
Połączenie z serwerem jest szyfrowane z użyciem klucza SSL
SZYBKA DOSTAWA KURIEREM LUB PACZKOMATEM
darmowa dostawa do polski od 500 PLN
New: Since spring 2016 the case is also available with black coating: A-100LC6V
Outside: approx. 445 x 275 x 160 mm
Inside: 2 x 84 HP x 3 U (two bus boards), useable depth for A-100 modules: approx. 80 mm in the power supply area (bottom right), resp. approx. 110 mm in the remaining area (measured from inner side of the front panel until end of the pc board of the module)
/>Weight (without modules): about 4 kg
Maximum Output Current:
with built-in A-100PSU3 (since about early 2016): +12V/2000 mA, -12V/1200mA, +5V/4000mA
In the area near the power supply (bottom right) no modules should be assembled that are sensitive against transformer hum. We recommend to assemble only control voltage modules in this area (e.g. LFO, ADSR, trigger delay, clock divider/sequencer, sequencer, slew limiter, MIDI interfaces and so on) but no audio modules (VCO, VCF, VCA, VCP, frequency shifter, ring modulator, spring reverb and so on). Even modules width increased depth (e.g. A-113 or A-126) cannot be assembled in the power supply area. They have to be placed in a position outside the power supply area (e.g. in the upper row). But this applies only for a few modules.
Normally it is no problem to arrange all modules by mounting modules with smaller depth in the power supply area.