Zamknij X

Doepfer A-148V Dual S&H Vintage Edition

Dostępny na zamówienie

Uzupełnij poniższy formularz, a skontaktujemy się z Tobą

Module A-148 (Dual S&H) has two identical sample & hold modules, designed to produce 'staircase' voltages.

Zakupy z Mode.M Modular są zawsze bezpieczne.
Połączenie z serwerem jest szyfrowane z użyciem klucza SSL

miesiące gwarancji
darmowa dostawa do polski od 500 PLN


The signal present at the sample input is sampled at a rate set by the signal at the trigger input, and held at that voltage at the S&H output. The exact shape of the staircase depends on the sort of waveform at the sample input: NOISE or RANDOM signals produce random patterns; an LFO produces rising or falling staircase patterns. Two LEDs for each S&H indicate the voltage (positive or negative) of the sampled signal. Similar modules: A-152 Voltage Addressed Track&Hold / Switch (Multiplexer) / Digital Outputs.
Since August 2005 an improved version of the module is manufactured: For each sub-module the operation mode S&H (sample&hold) or T&H (track&hold) can be selected by a jumper. In T&H mode the output signal follows the input signal while the trigger input is "high". As soon as the trigger input turns to "low" the last voltage is stored. The factory setting is S&H for the upper device and T&H for the lower device. At the bottom of this page the function of the jumpers is described. In addition the complete A-100 voltage range -12...+12V can be processed (no longer limited to -8...+8V as for the previous version).
The two versions can be identified by these details:
Version 1: four integrated circuits (2 x CD4053, 2 x TL064 oder TL084)
Version 2: three integrated circuits (1x DG442, 2 x TL084), see silk screen at the bottom of this page.
        Technical note:
The S&H/T&H function is realized by pure analog circuitry (electronic switch followed by a holding capacitor and buffer). Consequently the output voltage drifts a bit in the holding state
because the capacitor is discharged by parasitic resistors. The typical drift we measured is about 30 mV/minute and depends also upon environmental conditions like humidity or temperature. For the storage of control voltages over a long time used to control the pitch of a VCO the module is suitable to only a limited extent.
Width: 4 TE / 4 HP / 20.0 mm
Depth: 30 mm (measured from the rear side of the front panel)
Current: +20mA (+12V) / -20mA (-12V)

Z naszych informacji z tajemniczego źródła wynika, że używasz oprogramowania blokującego reklamy typu AdBlock
Nasza strona nie wyświetla ŻADNYCH reklam, jednak używanie AdBlocka może wpływać na funkcjonowanie strony
Prosimy o rozważenie wyłączenia oprogramowania blokującego reklamy na naszej stronie.